Case Studies

Repairing a water borehole

Published:

We repaired a water borehole for a commercial client after one of their boreholes was damaged during service works; the contractor involved was unable to resolve to problems, so we were called in.

A commercial company in Northern England, that has several large diameter boreholes to provide their water needs, suffered a breakdown and called the WB+AD Morgan's team to assist.

Unfortunately, one oftheir boreholes was damaged when service works were being undertaken.  The contractor involved was unable to resolve the issue. 

Also the string of 300mm uPVC casing and 300mm stainless steel screen was unsupported at surface and this had caused further damage through compression of the well screen.

We were commissioned to remove the existing uPVC casing & stainless steel wedge wire screen from the borehole, undertake a CCTV condition survey and re-line with a new string of stainless steel casing & screen.

The 64m of sand pack surrounding the casing & screen has created a sand lock, causing trapping of the casing & screen in the borehole. 

We designed and fabricated a hydraulic tool that was lowered approximately 115m into the borehole and placed against the stainless steel well screen.

High pressure water was then utilised to activate the hydraulic ram, which has a pointed end, to penetrate the screen and force open the 2mm wedge wire screen slots to some 25mm to allow the sand to flow from the annulus into the screen.

This process was then repeated along the length of the screen, allowing the sand to flow freely from the annulus into the screen.

Once completed an eductor airlift system weas lowered into the borehole and the sand “hoovered” clear of the borehole.  The sand was recovered and stored for re-use.  Once clear of all sand from inside, the casing & screen were lifted clear of the borehole.

The borehole was then CCTV surveyed and a new string of 300mm stainless steel casing & wedge wire screen installed.  The string was supported at surface to prevent compression and the annulus packed with sand for filtration. 

New headworks were fabricated to allow for attachment to the 150mm delivery pipework and a new pump installed on a stainless steel JSL riser system attached to a new stainless steel headworks.

Burst Tool
300mm casing & screen

Published by WB+AD Morgan on

Trustpilot